Finding the patterns behind the problems

Case Study - West hagbourne

We investigated a barn conversion to understand why parts of the home were holding onto moisture and why some rooms felt less fresh than others.

The challenge

The clues appeared throughout the home. There was condensation and mould around bedroom windows, higher humidity in some rooms, and not enough fresh air moving through the house.

We also found higher electrical activity around some sleeping areas. Looking at these findings together gave us a clearer picture of how the home was behaving as a whole.

Our findings

Moisture was trapped

Hard cement finishes and high ground levels were stopping parts of the older brick walls from drying naturally. Very high moisture readings were found in several rooms.

The bedrooms were electrically busier than they needed to be

Testing found higher electric fields around the sleeping areas. When the relevant socket circuits were switched off, the electrical environment became considerably quieter.

Moisture was gathering in the cooler
parts of the house

The north side was drying more slowly. Inside, that same pattern appeared around bedroom windows, where condensation, dampness and localised mould were found.

The air was holding onto more than expected

Humidity reached 71% in one bedroom, while some rooms had limited fresh air exchange. Dust, textiles, combustion sources and fragranced products were adding their own influences to the indoor air.

There wasn't one problem. There was a pattern.

Moisture, airflow and the sleeping environment initially appeared to be separate concerns. Our measurements showed how they were overlapping, particularly around the cooler sides of the house and its bedrooms.

The air was carrying lots of smaller influences

There wasn't a single air quality concern. Instead, the assessment found a combination of humidity, coarse particles, moderate VOCs and periods of reduced fresh air exchange.

The windows were telling us where
moisture was settling

Cooler surfaces were collecting condensation, with dampness, timber wear and localised mould appearing where moisture was repeatedly settling. Thermal imaging made the pattern particularly clear around one window, where the lower frame and sill were noticeably colder than the surrounding wall.

Then we switched off one circuit

The bedrooms initially showed higher electric fields around the sleeping areas. Switching off the relevant socket circuits dramatically lowered the measured levels, giving us a much clearer route towards a quieter electrical environment at night.

One practical fault was making moisture
harder to clear

Condensation in the bathroom suggested that humid air was not clearing properly. Looking above the ceiling revealed why: the extractor duct had been damaged, preventing the system from working effectively.

The results

A hidden ventilation problem became something practical to fix

The bathroom condensation had an explanation. Once we traced it back to the damaged ductwork above the ceiling, the homeowner had a clear route to restoring effective extraction and giving humid air a proper way out.

A simple test changed the approach to the bedrooms

Switching off the relevant socket circuits produced an immediate and dramatic reduction in the electrical readings around the sleeping areas. It gave the homeowner a simple way to create a quieter electrical environment at night, without making the bedroom more complicated.

Where to focus on moisture

The assessment showed that the condensation and mould were part of a wider moisture pattern. The homeowner now plans to improve breathability along the northern elevation, giving this cooler side of the house a better chance to dry naturally.

Your home deserves a proper look.

Book a Bedroom Health Analysis, or begin a conversation if you have questions first.

Available within 90-minute radius of Wantage, Oxfordshire including London. If you are outside this area, the Sleep Reset Programme is available online from anywhere in the world.